Tordi
Member
Threadstarter
Beim gelieferten Fahrwerk ist leider keine Einbau-Anleitung dabei, die vier fotokopierten Seiten enthalten nur Warnhinweise.
Da hätte ich allerdings doch noch Fragen:
- die stärkeren Federn kommen nach vorn, oder?
- was ist das hier und wo soll es hin? Hinten an die rahmenseitige Querlenker-Aufnahme?
- zu guter Letzt, was will man mir mit diesen Sätzen sagen?
"Do not drive lifted vehicle with stock rims without modifying or removing the rear sway bar. The ends of the sway bar must be cut off flush with the outside of the rubber mounting block located approx. 3" above the U-bolt top plate. Failure to do this will result in extensive damage to the interior side walls of the rear tires."
Was soll ich da vom Stabi abschneiden und was hat das mit den Serienfelgen zu tun?
Da hätte ich allerdings doch noch Fragen:
- die stärkeren Federn kommen nach vorn, oder?
- was ist das hier und wo soll es hin? Hinten an die rahmenseitige Querlenker-Aufnahme?
- zu guter Letzt, was will man mir mit diesen Sätzen sagen?
"Do not drive lifted vehicle with stock rims without modifying or removing the rear sway bar. The ends of the sway bar must be cut off flush with the outside of the rubber mounting block located approx. 3" above the U-bolt top plate. Failure to do this will result in extensive damage to the interior side walls of the rear tires."
Was soll ich da vom Stabi abschneiden und was hat das mit den Serienfelgen zu tun?